Remote Thermostat Installation; Power Cord - Quadra-Fire MTV-E2-CSB Installation Manual

MT VERNON E2
F. Remote Thermostat Installation
1. When mounting the thermostat on the wall, be sure to
follow your remote thermostat's installation instructions
carefully.
NOTE: The remote thermostat should be mounted
on an inside wall and not in direct line with the ap-
pliance convection air.
NOTE: If the remote thermostat is located too close
to the appliance, you may need to set the tempera-
ture setting slightly higher to maintain the desired
temperature in your home.
Photo of Thermostat separated from its docking station
below:
Tools Needed:
Phillips screw driver
Power Drill
Detach the remote thermostat from its docking station by
pulling them directly away from each other.
Using the fasteners and (if needed) anchors – included
with the remote transmitter packaging – fasten the docking
station to the wall.
IMPORTANT NOTES:
For best appliance performance, position the docking
station at 60 inches height from the floor, no further than 20
feet from the appliance, out of direct sunlight, and out of the
direct flow of convection air coming from the appliance or
structure's HVAC discharge air.
For instructions on thermostat function and interaction with
the appliance refer to the owner's manual.
20
1/4" or 7/64" drill bit
Tape Measure
G. Power Cord
1. Prior to installing the power cord, turn the dial control
"OFF".
2. Make sure the wall receptacle has 120vac output.
NOTE: Using a circuit protector can protect the appli-
ance circuits from power surges.
3. The appliance receptical is located on its lower, back
right hand corner. Install the cord to wall and appliance
reception.
4. Refer to owner's manual for appliance operation.
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
7080-131B
CAUTION
March 14, 2014