Signature Command System Operation Instructions - Monessen Hearth NB18 Installation Instructions Manual

NB18/NB24 Gas Log Set
FEATURES
Command Center
•
Easy Access Function Operation and System Confi gura-
tion
•
Operation Confi rmation/Fault Diagnostic Indications
(LED/Buzzer)
•
ON/OFF/HI/Med/Low Operation
•
Optional Wall Mounting
Control Board
•
Electronic Ignition
•
Pilot Lockout safety feature
•
Electric Power Regeneration from Thermopile to save
battery
•
6-hour Automatic Shut Down Option
•
Standing Pilot/Intermittent pilot Conversion
•
Previous settings Restoration Ability (Memory Off)
•
ON/OFF RF Remote Receiver
•
Optional Transmitter Learn Capability
Transmitter (Options)
(TSTSC is supplied with R-Models)
Three Flame Height Settings
Low battery Indication for Transmitter
Child Proof Lock-out
LCD Backlight
Security Codes 10,000
Countdown 6 hr Timer
Standard Thermostatic Control Mode
®
Smart Mode Thermostat
BATTERY INSTALLATION
The Command Center uses four (4) "AA" batteries to operate the system.
To Install Batteries:
1. Press down the battery door tabs and pull out to remove battery door.
2. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system is ready to operate.
5. The batteries should be replaced when the LED indicates low battery or at least once a year.
34

SIGNATURE COMMAND SYSTEM OPERATION INSTRUCTIONS

(Auto Flame)
RF Receiver
ON/OFF
NG/LP
Conversion
Control
Board
LED
OFF
Command
Center
Figure 49 -
Signature Command System Components
TSTSC TSMSC
X X
X X
X X
X X
X X
X X
X --
X --
To Thermopile
To Sensor
To Sparker
To Command
Center
To Stepper Motor
To Valve
ON
Master Switch
Battery Door
81D0107