Rock Wool Placement; Berkley Oak Log Placement - Monessen Hearth NB18 Installation Instructions Manual

LOG PLACEMENT

ROCK WOOL PLACEMENT

Before installing logs, place rockwool in dime size pieces
evenly over small burner ports starting in the rear of the
burner going towards the front. Avoid placing rock wool on
slots on each side of rear burner and on large yellow fl ame
ports on front of burner. After covering small burner ports,
discard any excess rock wool.
Wash hands after placing rock wool. Itching may occur.
NOTE: Installation instructions are the same for 18",
24", and 30" log sets. Pictures used in this manual
illustrate the 24" set. Some variation may exist between
the images and the set included with this manual.
Dime-sized Pieces
of Rock Wool
Figure 19 -
Place Rock Wool
Figure 21 -
Place Right Front Log #2
81D0107
FP2269
Right Front
Log #2
•
Use only rock wool provided with log
set.
•
Do not add additional rock wool
INSTALL 18", 24" AND 30" (F,R) BERKLEY
OAK LOGS ON NATURAL BLAZE BURNER
1. Place the #1 log (the "chunk") on the grate bar right side
of the burner adjacent to the controls. Figure 20
2. Place front right log (#2) on right pin located on burner
and right grate bar. Figure 21. slide Log #1 forward so
that it is tight against log #2.
Figure 20 -
Place Ember Chunk Log #1
3. Place right rear log (#3) on pin located
on rear support bracket and rest left side
of log on front right log. Figure 22.
LG630
NB18/NB24 Gas Log Set
.
Ember Chunk
Log #1
LG620
17