WDV Series Gas Fireplace
Features
command center
•
Easy Access Function Operation and System Configura-
tion
•
Operation Confirmation/Fault Diagnostic Indications (LED/
Buzzer)
•
ON/OFF/HI/Low Operation
control Board
•
Electronic Ignition
•
Pilot Lockout safety feature
•
Electric Power Regeneration from Thermopile to save bat-
tery
•
6-hour Automatic Shut Down Option
•
Convenient NG/LP Gas Type Conversion
•
Standing Pilot/Intermittent pilot Conversion
•
Previous settings Restoration Ability
•
Uninterrupted Operation During Power Outage (Automatic
Battery Backup)
•
ON/OFF RF Remote Receiver
•
Optional Transmitter Learn Capability
ac Module
•
Easy Snap-on Design
•
Embedded Compact 10 V AC Adapter with Auto Battery
Back up Feature
•
Remote Controlled Blower, Lighting, and Auxiliary AC
Outputs
transmitter
Three Flame Height Settings
Low battery Indication for Transmitter
Child Proof Lock-out
LCD Backlight
Security Codes
Thermostatic Control Mode
Three Brightness Settings for Lights
Three Speed Control for Blower
On/Off AUX Control
Programmable Timer to turn blower on and off
Battery InstallatIOn
The Command Center uses four (4) "AA" batteries.
to Install Batteries:
1. Press down the battery door tabs and pull out to remove battery door.
. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system is ready for use.
5. The batteries should be replaced when the LED indicates low battery.
30
sIGnature cOMManD systeM OperatIOn InstructIOns
RFSC
X
X
X
X
X
X
X
X
X
X
RF Receiver
ON/OFF
NG/LP
Conversion
control
Board
Battery Door
command
center
Master Switch
ON
LED
OFF
Figure 38 - Signature Command System
Components
FP1917
Signature components
8/08
To Thermopile
To Sensor
To Sparker
To Command
Center
To Stepper Motor
To Valve
AC Module
78D0011