Download Print this page

Handle Adjustment - Britax STRIDER 4 Instruction Manual

Advertisement

7.
CANOPY
A.
Attach canopy by inserting both tabs into plastic socket
in seat frame until they lock into sockets as shown.
B.
To firmly fit canopy attach hook and loop sets around
the seat unit.
C.
To adjust open by pulling the canopy forward or close
by pushing back. For extra protection pull visor out
from under canopy.
D.
To remove canopy push in the base of each tab firmly to
unlock and pull up from plastic socket.
E.
To open window pull flap away from canopy and roll up,
attach with elastic and toggle.
8.
BACKREST ADJUSTMENT
A.
To adjust, fully release lever to top position, continue
holding lever open and tilt seat to desired
position. There are 3 seat positions while seat is facing
forward:
1.
Highest position - UPRIGHT
2.
Middle position - SEMI RECLINE
3.
Lowest position - LAYBACK
Caution: Ensure that your child's limbs are in centre of seat
before adjusting the backrest. Be prepared to support your
child's weight when adjusting the backrest.
06
www.britax.com.au
9.
WARNING: Use this harness at all times.
A five-point harness is provided to restrain your child.
To secure the child in the harness, push buckle (A) and
(B) into the buckle housing (C) until the buckle prongs
snap into position. Carefully adjust the harness by
pulling the slider (D) until the desired fit is achieved in
the lap, shoulder and crotch straps. Always adjust the
A
harness when changing the seating position of the child.
To release the buckle, squeeze the top and bottom prongs.
10. LEG SUPPORT - ADJUSTMENT
A.
B
B.
11. BRAKES
E
A.
B.
Note: Always apply rear brakes when parking stroller.

12. HANDLE ADJUSTMENT

A.
A
HARNESS - ADJUSTMENT
To lower leg support, press in and hold both left and
right buttons to unlock them, then tilt leg support
downward.
To raise leg support, lift up to desired level.
To lock rear brakes, press down all the way on brake
lever beside right rear wheel until both wheels lock.
To unlock, firmly lift up brake lever all the way until
wheels unlock.
There are three handle height positions, squeeze the
button at centre of handle to release and adjust
handle in either high or low position.
www.britax.com.au
A
A
A
07

Advertisement

loading