Advertisement
Using your machine
IMPORTANT: When using on carpets, always make sure the microfibre cleaning pad covers the floorhead entirely
before using the carpet glider.
Only use the carpet glider when refreshing carpets. Never use the carpet glider on hard floors.
Never leave the floor steamer in one spot for extended period of time or with a damp or wet pad attached
as this may damage the floor surface.
Do not use detergent when refreshing carpets.
Refreshing carpets
Place the microfibre
pad on the floor white
side facing up.
Place steamer onto
pad making sure the
entire pad covers
the floorhead.
Pull handle backwards
to recline.
With microfibre pad
attached, slide the
floorhead into the carpet
glider, then push the
back of the floorhead
downwards into the clip
to secure. The carpet
glider should only be used
when refreshing carpets.
To produce steam squeeze
the trigger in short bursts.
To prevent over wetting
carpets avoid holding
the trigger continuously.
Plug the steamer into
mains and slide the
On/Off switch to "On".
The green light will
illuminate when it is ready
to use. The steamer will
automatically set to Max
steam (no detergent).
Move the steamer slowly
backwards and forwards
across the carpet.
To refresh your carpets
press the button on the
control panel to select
Steam Only LOW.
Do not use detergent
when refreshing carpets.
Advertisement
