Cadillac 2010 Escalade ESV Owner's Manual page 204

Turn the headlamp control to off and then back to the
headlamp on position to make the headlamps stay on
for an additional 10 minutes.
®
IntelliBeam Intelligent High-Beam
Headlamp Control System
For vehicles with this feature, be sure to read this entire
section before using it.
®
IntelliBeam is an enhancement to the vehicle's
headlamp system. Using a digital light sensor on the
rearview mirror, this system will turn the vehicle's
high-beam headlamps on and off according to
surrounding traffic conditions.
®
The IntelliBeam system turns the high-beam
headlamps on when it is dark enough, there is no other
traffic present, and the IntelliBeam
Turning On and Enabling IntelliBeam
Press and release the IntelliBeam
rear view mirror. The IntelliBeam
mirror will turn on to let you know the system has been
turned on. Once the system has been turned on, it will
remain on each time the vehicle is started. Additionally,
®
the IntelliBeam system must be enabled.
4-12
®
system is enabled.
®
®
button on the inside
®
indicator on the
I n f o r ma t i o n P r o v i d e d b y :
®
To enable the IntelliBeam
lamp control to AUTO, with the turn signal/multifunction
lever in its neutral position. The High-Beam On Light
will appear on the instrument panel cluster when the
high-beams are on. See Highbeam On Light on
page 4 40.
Driving with IntelliBeam
®
IntelliBeam will only activate your high-beams when
driving over 20 mph (32 km/h).
The high-beam headlamps will remain on, under the
automatic control of IntelliBeam
following situations occur:
The system detects an approaching vehicle's
headlamps.
The system detects a preceding vehicle's
taillamps.
The outside light is bright enough that high-beam
headlamps are not required.
The vehicle's speed drops below 15 mph
(24 km/h).
system, turn the exterior
®
®
, until any of the