Cadillac 2010 Escalade ESV Owner's Manual page 149

It is possible for the PASS-Key
the transponder value of a new or replacement key. Up
to 10 keys may be programmed for the vehicle. The
following procedure is for programming additional keys
only. If all the currently programmed keys are lost or do
not operate, you must see your dealer or a locksmith
who can service PASS-Key
and programmed to the system.
See your dealer or a locksmith who can service
®
PASS-Key III+ to get a new key blank that is cut
exactly as the ignition key that operates the system.
®
III+ decoder to learn
®
III+ to have keys made
I n f o r ma t i o n P r o v i d e d b y :
To program the new additional key:
1. Verify that the new key has a
2. Insert the original, already programmed, key in the
ignition and start the engine. If the engine will not
start, see your dealer for service.
3. After the engine has started, turn the key to
LOCK/OFF, and remove the key.
4. Insert the new key to be programmed and turn it to
the ON/RUN position within five seconds of turning
the ignition to the LOCK/OFF position in Step 3.
The security light will turn off once the key has
been programmed.
5. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you lose or damage your PASS-Key
your dealer or a locksmith who can service
®
PASS-Key III+ to have a new key made.
Do not leave the key or device that disarms or
deactivates the theft deterrent system in the vehicle.
1
stamped on it.
®
III+ key, see
3-25