Subaru 2001 IMPREZA Service Manual page 51

BRAKE
6) Connect parking brake cable to parking lever.
7) While positioning shoes (one at a time) in groove
on wheel cylinder, secure shoes.
8) Fix shoes by connecting hold-down cup to hold-
down pin.
9) Connect lower shoe return spring.
10) Set the outside diameter of brake shoes less
than 0.5 to 0.8 mm (0.020 to 0.031 in) in compari-
son with the inside diameter of brake drum.
11) Install hub.
<Ref. to DS-27, INSTALLATION, Rear Axle.>
12) Connect brake pipe, and tighten brake pipe
flange nut.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
13) Install brake drum.
14) After installing brake assembly, bleed air from
brake line.
REAR DRUM BRAKE ASSEMBLY
G4M0409
G4M0399
BR-50
C: DISASSEMBLY
1) Remove right and left dust boots from wheel cyl-
inder.
(1) Bleeder cap
(2) Bleeder screw
(3) Spring
(4) Cylinder
(5) Cup
(6) Piston
(7) Boot
2) Remove piston, cup, spring and air bleeder
screw and cap.
B4M1126B