Subaru 2001 IMPREZA Service Manual page 34

3. 16 INCH TYPE
1) Clean caliper body interior using brake fluid.
2) Apply a coat of brake fluid to piston seal and fit
piston seal in groove on caliper body.
3) Apply a coat of brake fluid to the entire inner sur-
face of cylinder and outer surface of piston.
4) Insert piston into cylinder.
CAUTION:
Do not force piston into cylinder.
5) Apply a coat of specified grease to boot and fit in
groove on ends of cylinder and piston.
Grease:
NIGLUBE RX-2 (Part No. 003606000)
To facilitate installation, fit boot starting with piston
end.
Piston seal
6) Position boot in grooves on cylinder and piston.
7) Install boot ring. Be careful not scratch boot.
FRONT DISC BRAKE ASSEMBLY
BR0016
Piston
Piston boot
Boot ring BR0017
BR-33
E: INSPECTION
1) Repair or replace faulty parts.
2) Check caliper body and piston for uneven wear,
damage or rust.
3) Check rubber parts for damage or deterioration.
BRAKE