Maintenance - Filters - Morphy Richards VC73410 MUK Instruction Book

VC73410MUK Rev4_Instruction Book 31/10/2012 11:18 Page 9
Hold the dust canister
4.
the lower bin emptying release button (15). Tap
gently to empty contents. Press the door shut
again until it clicks into place.
If required, turn the dust canister
5.
down over the bin and press the upper bin
emptying release button (12).
Tap gently to remove contents.
Use a dry cloth or paper towel to remove debris
stuck to the screen filter
canister. Press the door shut again until it clicks
into place.
Remember to periodically (at least once a month)
clean the pre-motor filters (see 'Cleaning the
pre-motor flters' on this page) before refitting the
dust canister.
Replace the dust canister on top of the motor
.
6
base (18).
Hook the two dust canister release latches
.
7
onto the tabs on the sides of the dust canister
(13) and push down to lock.
(13) over a bin and press
(13) upside
(14) inside the dust
Screen
Filter
(16)

Maintenance - filters

The guarantee may be invalidated if the motor is
damaged due to: using the appliance without
the filters installed; not cleaning the filters; or
not replacing damaged filters.
Cleaning the pre-motor filters
To maintain suction, the pre-motor filters must
be cleaned each time the dust canister
emptied.
Remove the dust canister.
1.
Pull the 2 filters out from the top of the motor
2.
base (18).
Wash the filters in cold water and thoroughly air
3.
dry before re-fitting.
IMPORTANT: Do not wash filters with hot water
or detergents.
IMPORTANT: Do not use heated appliances to
dry filters.
Replace the felt filter in first, then the foam filter.
4.
Replace the dust canister.
5.
Cleaning the exhaust filter
The exhaust filter (20) must be cleaned at least
every three months.
The exhaust filter is located on the front of the
motor base (18).
Remove the filter cover.
1.
(13) is
Pre-Motor
Foam Filter
Felt Filter
(20)
9