Table of Contents
Advertisement
VC700006 MUK Rev 1.qxp_Instruction Book 03/11/2014 14:49 Page 9
Storage
After use, the product may be stored vertically.
Make sure the cord is fully rewound and the
telescopic tube
(17)
size. Attach the floor nozzle parking hook into the
slot on the bottom of cleaner to hold the
hose/tube assembly.
Maintenance - filters
The guarantee may be invalidated if the motor is
damaged due to: using the appliance without
the filters installed; not cleaning the filters; or
not replacing damaged filters.
Cleaning the motor protection filter
Whenever the dust bag is changed, the motor
protection filter must be checked and cleaned.
This is especially important if there has been a
leak/tear in the dust bag and dust has entered
the dust bag compartment.
This filter is located inside the dust bag / filters
compartment, next to the dust bag (to access,
see point 1 of 'Changing the dust bag' on page
8).
Pull the tab at the top of the filter cage to open
1.
the cage and access the filter.
To clean, shake the filter thoroughly.
2.
After 5 dust-bag changes, the filter must be
replaced with a new filter. If the filter is not
cleaned and regularly replaced the performance
will be impaired.
is retracted to the minimum
IMPORTANT: Never use the cleaner without the
motor protection filter fitted.
Return the motor protection filter to its housing
5.
and replace back into the vacuum cleaner,
ensuring the motor protection filter cage is
securely in place.
Changing the exhaust filter
The exhaust filter must be checked every time
the dust bag is replaced. We recommend
changing after every five dust bag changes.
This filter is located inside the dust bag
compartment, above the motor protection filter
(to access, see point 1 of 'Changing the dust bag'
on page 8).
To replace, lift the filter from its location and then
refit the new filter.
Problems?
The product has lost suction power
Check the settings of the suction power dial
and the hose handle suction control (14).
Check the dust bag, if fine dust has been sucked
up, eg. talcum powder or plaster dust, this will
quickly block the pores of the dust bag so the
dust bag will need to be replaced even though it
may not appear full.
Check the motor protection filter. Clean or replace
as necessary.
Check the hose, tube and nozzles for any
blockage. Operate the product with/without each
item to note if there is any difference in the
suction/sound caused by hidden blockages, eg.
in the hose. Clear the blockage to restore full
suction power.
The floor nozzle seems hard to push or
sticks to the floor
Check the pedal on the combination floor nozzle
(19)
is set for the correct floor type, ie. brushes up
for carpets, brushes down for hard-floors.
Check the suction power dial
appropriate setting.
The wheels do not seem to rotate
See 'Stair-lock wheels' on page 7.
(10)
(10)
is set to the
9
Advertisement
Table of Contents
