Advertisement
5
of four holes located around opening.
b. Remove nuts.
c. Repeat steps a and b for remaining studs.
b. Position ½" sealing rope in groove. Overlap ends at least one inch.
c. Install burner mounting plate. Use ½" washers and nuts.
b. Position
c. Secure assembly to section. Use
nuts.
3. Mount cleanout plate over opening. Secure with nuts and washers.
4. Repeat steps 1 through 3 for remaining cleanout plates.
The boiler contains ceramic fiber
and fiberglass materials. Use care
when handling these materials per
instructions on page 38 of this
manual. Failure to comply could
result in severe personal injury.
Part No. 550-141-935/0215
1
/
" continuous bead of sealing rope adhesive in groove around opening in section.
8
1
/
" continuous bead of sealing rope adhesive in groove on observation port.
8
3
/
" sealing rope in groove.
8
5
/
" - 18 x ¾" slotted head screws.
16
and carbon monoxide emissions, resulting in severe personal injury or death.
Cleanout plate assembly
9
Advertisement
