Advertisement
Weil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fired Burners
14
If sealing rope is used, apply
gas-tight seal.
3. Mount burner into opening in burner mounting plate.
15
injury or death if power source is not disconnected
before installing or servicing boiler and burner.
2. Follow burner manual and wiring diagram found in burner
3. Use 14 ga. wire for operating and safety circuit wiring.
16
pressure will vary with each installation.
3. Starting on lowest floor, open air vents one
Repeat with remaining vents.
4. Refill boiler to correct pressure.
boiler is ready to be fired.
2. Fill to normal waterline, halfway up gauge
glass.
3. Recommend boiler water pH 7.0 to 8.5.
32
1
/
" continuous bead of rope adhesive
8
2. Refer to burner manual for start-up and service.
at test opening. Tighten screws to secure in position. Plug test opening with 3/8"
bolt provided with damper assembly.
Maintain gas-tight seal between burner mounting
flange and plate to prevent damage to air tube.
5. Secure with furnished bolts.
3. Oil piping – use flare-type fittings, not compression type.
Do not use compression or soldered fittings. No safe
repair can be made. Severe personal injury, death or
substantial property damage will result.
regarding propane gas odorant.
assure proper operation. Do not fire boiler without water. Sections will
overheat, damaging boiler and resulting in severe property damage.
2
2
Part No. 550-141-935/0215
Advertisement
