Notes And Precautions; Operation Instruction - Dimplex FTE10 Installation And Operating Instructions Manual

CONTROL PLATE DESCRIPTION

OPERATION INSTRUCTION

Starting the unit
Allow the unit to stand upright for 24hrs to let the compressor stabilize
before first use or when transported.
1. Firstly, turn the humidity control switch to the "OFF" position.
2. Plug in the dehumidifier.
3. Turn on the humidity control switch (clockwise) and set it at the desired
humidity level, please refer to table in point 4 below (e.g. position"4 = 60%).
4. For assistance in drying clothes in a laundry/ utility room, please select
maximum dial position for continuous operation and maximum moisture
removal.
Turning off the unit
1. Turn the humidity control switch fully anticlockwise to the "OFF" position
and the power supply is cut off and the unit stops operating.
2. If the dehumidifier is not in use for a long time, please disconnect the power
cord plug from the supply outlet.

NOTES AND PRECAUTIONS

1. The dehumidifier will not operate if the humidity dial is set lower than the
ambient humidity e.g. room humidity 40% and dial setting 2 or 4. In other
words the higher the humidistat dial setting e.g. position 8 the dehumidifier
will attempt to dry the ambient humidity to 20% (RH) relative humidity.
2. When the water tank is full an automatic float switch shuts down the
product and the tank full LED illuminates. Remove the water storage tank
and empty its contents, carefully replace the empty water tank back in
position, the unit will now automatically restart operating.