Notes And Precautions - Dimplex DXDH10N Installation And Operating Instructions Manual

Turning off the unit
1. Turn the humidity control switch fully anticlockwise to the "OFF" position and
the power supply is cut off and the unit stops operating.
2. If the dehumidifier is not in use for a long time, please disconnect the power
cord plug from the supply outlet.

NOTES AND PRECAUTIONS

1. The dehumidifier will not operate if the humidity setting is higher than the
ambient humidity.
2. When the water in the tank is full an automatic float switch shuts down the
product and the water level indicator light illuminates. Remove the water
storage tank and empty its contents, carefully replace the empty water tank
back in position, the unit will now automatically restart operating.
3. When the unit stops, you have to wait for 3 minutes before you can
restart the unit to protect the compressor from damage.
4. The following table indicates the approximate relative humidity setting against
its related position number on the humidity control switch:
5. The operational temperature range for this unit is 5-35°C.
6. Other than on the case of note 2 above, where the dehumidifier does not
start, the operational light does not illuminate or the dehumidifier intermittently
stops for unknown reasons, please check the plug and power supply for poor
connection. If the plug and power supply are in good condition, wait for 10
minutes and restart the unit (it can take about 10 minutes for the unit to reset).
If the unit still does not start after 10 minutes, please contact your retailer or
the manufacturer for repair.
7. When the dehumidifier is in operation, the running compressor will produce
heat. This is normal and may potentially raise the room temperature.
8. When the product is defrosting, the defrost light will illuminate.
CONTROL SWITCH
POSITION NO.
8
7
6
4
2
APPROXIMATE
HUMIDITY SETTING
20
﹪
30
﹪
40
﹪
60
﹪
80
﹪