Starting The Unit; Turning Off The Unit; Notes And Precautions; Operation Instruction - Dimplex DXDH10N Installation And Operating Instructions Manual

OPERATION INSTRUCTION

Starting the unit

1. Firstly, turn the humidity control switch to the "OFF" position.
2. Plug in the dehumidifier.
3. Turn on the humidity control switch(clockwise) and turn the same switch to
the reading of the desired humidity(60% in general as shown on position"4").

Turning off the unit

1. Turn the humidity control switch fully anticlockwise to the "OFF" position and
the power supply is cut off and the unit stops operating.
2. If the dehumidifier is not in use for a long time, please disconnect the power
cord plug from the supply outlet.

NOTES AND PRECAUTIONS

1. The dehumidifier will not operate if the humidity setting is higher than the
ambient humidity.
2. When the water in the tank is full an automatic float switch shuts down the
product and the water level indicator light illuminates. Remove the water
storage tank and empty its contents, carefully replace the empty water tank
back in position, the unit will now automatically restart operating.
3. When the unit stops, you have to wait for 3 minutes before you can restart
the unit to protect the compressor from damage.
4. The following table indicates the approximate relative humidity setting
against its related position number on the humidity control switch:
5. The operational temperature range for this unit is 5-35° C.
CONTROL SWITCH
POSITION NO.
8
7
6
4
2
APPROXIMATE
HUMIDITY SETTING
20﹪
30﹪
40﹪
60﹪
80﹪