Important
Parameter
Alarm output
Activate
Refresh
Record
Figure 7- 46 Alarm I/O Config Menu
The alarm output port should not be connected to high power load
directly (It shall be less than 1A) to avoid high current which may result
in relay damage. Please use the co contactor to realize the connection
between the alarm output port and the load.
Please refer to the following sheet for detailed information.
Function
There are three output channels (Multiple choices).
Please note the displayed alarm output channel amount here may
vary due to the different series.
Enable/disable alarm output device. After the Web activated the
alarm, you need to cancel the channel and then click the
activation button to cancel the alarm, or you need to cancel the
alarm in the pop-up dialogue box in local-end.
Record control interface is shown as in Figure 7-48.
Search alarm output status.
178