Honeywell CADVR-04D User Manual page 187

Parameter Function
Alarm System can delay the alarm output for specified time after alarm
Latch ended. The value ranges from 1 second to 300 seconds.
Show System pops up the alarm messages in the monitor interface.
message
Buzzer Once you check the box here, the buzzer beeps when an alarm
occurred.
Alarm System can upload the alarm signal to the centre (Including alarm
upload centre.
Record System auto activates current channel to record once alarm occurs
Channel (working with alarm activation function). Please note current
device shall be in auto record mode (Chapter 4.4 Schedule).
Record System can delay the record for specified time after alarm ended.
Latch The value ranges from 10s to 300s.
Email Please draw a circle to enable email function. System can send out
email to alert you when alarm occurs and ends.
Tour Display the selected video in local monitor window.
Tour interval and tour mode are set in DVR local menu (chapter
5.3.9 Display )
PTZ Here you can set PTZ movement when alarm occurs. Such as go to
activation preset x when there is an alarm.
The PTZ configuration events include preset, tour, and pattern.
Capture You need to input capture channel number so that system can
backup snapshot file when alarm occurs.
Copy It is a shortcut menu button. You can copy current channel setup to
one or more (all) channels.
Save You can click save button after you complete setup for one
channel, or you can complete the whole setups and then click save
button.
Refresh Click this button to get device latest configuration information.
Detect
Analysis the video, system enable motion detection alarm when it
detects the motion signal reached the specified sensitivity.
The detection interface is shown as in Figure 7-42.
170