Renault Espace Technical Note page 61

AUTOMATIC TRANSMISSION
23
Multifunction switch
SETTING THE MULTIFUNCTION SWITCH
Control shaft in position
NEUTRAL:
Place two electrical terminals on the position
checking tabs.
14827S
Turn the multifunction switch by hand until the
electrical setting contact closes (resistance at the
contact terminals= 0 Ω).
Tighten the bolts to a torque of 1 daNm.
AFTER TIGHTENING, THE ELECTRICAL CONTACT
SHOULD REMAIN CLOSED.
TIGHTEN THE SCREWS, NUTS, BOLTS TO THE
SPECIFIED TORQUES.
Check that the gears operate and change
correctly.
23-17