Checking the setting
Ensure that the tensioner
marks are positioned correctly
before checking the timing set-
ting.
Fit the Top Dead Centre pin
(check that the marks made on
the camshaft pulleys by the
operator are aligned).
Fit (without using force) cams-
haft setting tool Mot. 1496
(the camshaft grooves should
be horizontal and offset down-
wards). If the tool does not en-
gage, the timing setting and
tensioning procedure must be
repeated.
15104R
TOP AND FRONT OF ENGINE
Timing belt
Refit the phase shifter blanking piece (1) (fitted
with its new seal) tightening it to a torque of 2.5
daN.m.
16019-7R
11-19
11
15106-1S