TP-Link Archer C2600 User Manual page 15

Chapter 2
3 ) Connect the modem to the Internet port on your router with an Ethernet cable.
4 ) Turn on the modem, and then wait about 2 minutes for it to restart.
5 ) Turn on the router.
6 ) Verify that the following LEDs are on and solid before continuing with the
configuration.
Note:
If the 2.4G LED and 5G LED
and check the LEDs again in a few seconds later.
Tips:
For optimum performance, orient the four antennas as shown in the drawing below.
2. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
• Method 2: Wirelessly
Connect wirelessly by using the SSID (Network Name) and Wireless Password/PIN
printed on the product label at the bottom of the router.
Power
2.4G 5G
On
On On
are off, please press the Wi-Fi On/Off button on the side panel for 2 seconds
30°
Ethernet cable
Connect the Hardware
Internet
On
30°
11