Installing The Wall Control - Hunter 23348 Installation And Operation Manual

You must install the wall control included with this product in order to
control the fan speed. Only one wall control can be used to control the
fan speed.
7-1. Turn circuit breaker to the fan wall switch OFF.
7-2. Remove the wall plate and switch.
7-3. With the "Up" arrow in the wall control back cover facing up,
connect each of the 2 household black wires to each of the 2 black
wall control wall box assembly wires with wire connectors. The
order is not important. Connect the ground wire from the wall
control to the ground wire in the wall.
7-4. Install the wall box assembly with screws.
7-5. Attach your wall plate to the control wall box assembly with
screws.
Note: You may need a different wall plate to match your decor,
or because you have a multigang switch. If so, you can purchase a
Decora®-style switch plate at your local home center or hardware
store. Decora® is a regsitered trademark of Leviton Manufacturing
Corporation.
7-6. Slide the round wall control knob onto the shaft sticking out of
the wall box assembly.
7-7. Turn the circuit breaker back on.
7-8. To operate fan, turn the wall control knob to the desired speed.
Wire
Connector
7 • Installing the Wall Control
10
42664-01 • 06/09/08 • Hunter Fan Company
Wall
Plate
Switch
Step 7-2
Step 7-3
Wall
Shaft
Plate
Knob
Steps 7-4 – 7-5
Wall Box
Assembly