Peel Off The Lamination Film - Sharp LC-40LE820E Service Manual

[2] Peel off the Lamination Film

1. LC-40LE820E/LU820E
1. Peel off the back side laminetion film
2. Fit the panel
3. Fit the S-PWB to the P-chassis
Panel reference point
4. Peel off the front side lamination film
Ionized air blowers
Back side
GND
S-PWB side
Fit
Claw fit 4 points
GND
Panel reference point
LC-40/46/52LE820E, LC-40/46LU820E
Caution
* Ground S-PWB connectors while peeling off lamination film.
* Use a ionized air blower while peeling off lamination film.
Wind from the blower should cover whole surface of panel.
* Never touch polarizer surface after lamination film is removed.
P-chassis(B) side
Check (upper claw 4 points)
Ionized air blowers
Front side
S-PWB side
Caution
* Ground S-PWB connectors while peeling off lamination film.
* Use a ionized air blower while peeling off lamination film.
Wind from the blower should cover whole surface of panel.
* Never touch polarizer surface after lamination film is removed.
2 – 4