Sharp LC-40LE820E Service Manual page 143

2. LC-46LE820E/LU820E
Attach LED-PWB & Angle with screw.
Angle(A) x2
LANGT0061TPZZ
Align the directions.
Hook part of angle and
connector of LED-PWB.
reverse side
of connector
LED-PWB x4
RUNTK4461TPZZ
Angle(B) x2
LANGT0060TPZZ
Note
Use same rank LED-PWB in a module.
Use ionized air blowers.
Use conductive wristband or conductive shoes.
Use JIG for hold angle.
Don't touch LED surface as much as possible.
Don't touch LED with screw or driver bit.
Attach LED-PWB Angle with screw.
Angle(A) x2
LANGT0061TPZZ
screw x32
LX-BZ2103TPZZ
screw lock (blue)
Angle(B) x2
LANGT0060TPZZ
Note
Use same rank LED-PWB in a module.
Use ionized air blowers.
Use conductive wristband or conductive shoes.
Don't touch LED surface as much as possible.
Don't touch LED with screw or driver bit.
stamp "0061"
stamp "0060"
Identify the LED rank by the
alpha-numerical description
of 2 digits.
(For example "01")
1st
stamp "0061"
Positioning hole
S-PWB side
Positioning hole
1st
stamp "0060"
LC-40/46/52LE820E, LC-40/46LU820E
Ionized air blowers
2 digits
Ionized air blowers
1st
Positioning hole
1st
stamp "0061"
2 – 2
Screw x44
LX-SZ2203TPZZ
reverse side
of connector
stamp "0060"
Note of tightening
Except as otherwise noted in
no particular order tightening.
Positioning hole
Align the directions.
Hook part of angle and
connector of LED-PWB.