Table of Contents
Advertisement
1-4. SAFETY AND NOTIFICATION
* Please remember to put a Mylar below the hard disk drive while installing it.
* Please note that WinCE does not support for external CF card.
Following messages are safety reminders on how to protect your systems from
damages. And thus, helps you lengthen the life cycle of the system.
1. Check the Line Voltage
a. The operating voltage for the power supply should cover the range of DC
15V~24V, otherwise the system may be damaged.
2. Environmental Conditions
a. Place your PPC-7365F on a sturdy, level surface. Be sure to allow enough
room on each side to have easy access.
b. Avoid extremely hot or cold places to install your PPC.
c. Avoid exposure to sunlight for a long period of time (for example in a
closed car in summer time. Also avoid the system from any heating
device.). Or do not use PPC-7365F when it's been left outdoors in a cold
winter day.
d. Bear in mind that the operating ambient temperature is from 0°C up to
+45°C.
e. Avoid moving the system rapidly from a hot place to a cold place or vice
versa because condensation may come from inside of the system.
f. Place PPC-7365F against strong vibrations, which may cause hard disk
failure.
g. Do not place the system too close to any radio active device. Radioactive
device may cause interference.
3. Handling
a. Avoid putting heavy objects on top of the system.
b. Do not turn the system upside down. This may cause the floppy drive and
hard drive to mal-function.
c. Do not remove the diskette from the Floppy drive while the light is still on.
If you remove the diskette while the light is on, you may damage the
information on the diskette.
4. Good Care
a. When the outside of the case is stained, remove the stain with neutral
washing agent with a dry cloth.
b. Never use strong agents such as benzene and thinner to clean the system.
c. If heavy stains are present, moisten a cloth with diluted neutral washing
agent or with alcohol and then wipe thoroughly with a dry cloth.
d. If dust has been accumulated on the outside, remove it by using a special
made vacuum cleaner for computers.
PPC-7365F USER
'
S MANUAL
Chapter 1 Introduction
Page: 1-9
Advertisement
Table of Contents
