Icom IC-7600 Instruction Manual page 16

1
PANEL DESCRIPTION
■ Front panel (contnued)
TIMER
POWER
TRANSMIT
TUNER
BAL
PHONES
ELEC-KEY
NB
AF RF/SQL
MIC
MIC GAIN RF POWER BK-IN DELAY KEY SPEED
$6 MEMORY UP/DOWN SWITCHES [∫]/[√] (p. 99)
➥ Push to select the desred memory channel.
• Memory channels can be selected both n VFO and
memory modes.
➥ Push to select the desred memory channel d-
rectly after pushng [F-INP ENT] and a memory
channel number.
$7 MEMORY WRITE SWITCH [MW] (p. 101)
Stores the selected readout frequency and operat-
ng mode nto the dsplayed memory channel when
pushed and held for 1 sec.
• Ths functon s avalable both n VFO and memory
modes.
$8 MEMO PAD-WRITE SWITCH [MP-W] (p. 104)
Programs the dsplayed readout frequency and op-
eratng mode nto a memo pad.
• The 5 most recent entres reman n memo pads.
• The memo pad capacty can be expanded from 5 to 10
n others set mode. (p. 132)
$9 MEMO PAD-READ SWITCH [MP-R] (p. 104)
Each push calls up a frequency and operatng
mode n a memo pad. The 5 (or 10) most recently
programmed frequences and operatng modes
can be recalled, startng from the most recent.
• The memo pad capacty can be expanded from 5 to 10
n others set mode. (p. 132)
9
T X RX
HF/50MHz TRANSCEIVER
MONITOR
NR
NR
F- 1 F- 2
SSB CW RTTY/PSK
$6
SPLIT LOCK
AUTO
F- 3 F- 4 F- 5 F- 6
TUNE
AM/FM FILTER EXIT/SET REC PLAY
VOICE MEMORY
%0 VFO/MEMORY SWITCH [VFO/MEMO]
➥ Swtches the selected readout operatng mode
between the VFO and memory when pushed.
(pgs. 26, 99)
➥ Transfers the memory contents to VFO when
pushed and held for 1 sec. (p. 102)
%1 QUICK TUNING SWITCH [TS]
➥ Turns the quck tunng step ON and OFF. (p. 29)
• Whle the quck tunng ndcator, "Z," s dsplayed
above the frequency ndcaton, the frequency can
be changed n programmed kHz steps.
• 0.1, 1, 5, 9, 10, 12.5, 20 and 25 kHz steps are aval-
able for each operatng mode ndependently.
➥ When the quck tunng step s ON, push and hold
for 1 sec. to enter quck tunng step set mode.
(p. 29)
➥ When the quck tunng step s OFF, push and
hold for 1 sec. to turn the 1 Hz tunng step ON
and OFF. (p. 30)
%2 AUDIO PEAK FILTER/TWIN PEAK FILTER
SWITCH [APF/TPF]
During CW mode operation (p. 39)
➥ Push to turn the audo peak filter ON and OFF.
• "
➥ When the audo peak filter s ON, push and hold
for 1 sec. to select the APF passband wdth
from WIDE, MID and NAR or from 320, 160 and
80 Hz dependng on APF type settng (SOFT or
SHARP).
During RTTY mode operation (p. 47)
➥ Push to turn the twn peak filter ON and OFF.
• "
• The ndcator on ths swtch lghts green when the
functon s actvated.
$7 $8 $9 %0 %1
1.8 3.5 7 TWIN-PBT
1 2 3
SPLIT
10 14 18
4 5 6
DUAL
WATCH 21 24 28
7 8 9
GENE 50 F-INP
0
CHANGE ENT
MP-W MP-R PBT - CLR
NOTCH
MAIN
/SUB
NOTCH CW PITCH
M.SCOPE MW VFO/MEMO
XFC TS
RIT TX
RIT/ TX
SPEECH
LOCK
" appears when audo peak filter s n use.
" appears when twn peak filter s n use.
%2
APF/TPF
%3
%4
%5
CLEAR