Rinnai RB-3002E-CB Operation & Installation Manual page 12

Connecting the supply cable to the power mains

An adequate electrical supply must be provided for
this unit. Check voltage on rating label.

The installer must ensure that the correct electrical
connection has been made and that it is compliant
with local safety regulations.

If the appliance is being directly connected to the
power mains supply, an omnipolar circuit breaker
must be installed with a minimum gap of 3mm
between the contacts, suitable for the load
indicated and complying with current electrical
regulations (the earthing wire must not be
interrupted by the circuit breaker). The supply cable
must not come into contact with surfaces with
temperatures higher than 50
Before connecting to power supply, ensure that:

The appliance is correctly and efficiently earthed.

Use an electrical connector with earth that is
correct for your location. The electrical connection
of this appliance must be connected to earth
(where applicable): Green & Yellow = EARTH;
Blue = NEUTRAL; Brown =LIVE

The socket can withstand the maximum power of
the appliance, and voltage within the value range
indicated on the rating label attached to the
appliance.

The basic safety requirement should be tested by
qualified persons only. Multiple plugs and extension
cables must not be used. Overloading is dangerous
and may cause a fire hazard.

Once the appliance has been installed, the power
supply and electrical socket must be easily
accessible.
0
C.
10
Electrical connection must be performed by a qualified
electrician.
The installer must ensure that the correct electrical
connection has been made and that it is compliant with
local safety regulations.
The manufacturer cannot be held responsible for any
unit malfunction due to an inadequate electrical supply
nor any liability should these safety measures not be
observed.