Answering system
Remote access
You can access the answering system remotely by dialing your home
telephone number from any touch-tone telephone.
To remotely access the answering system
1.
Dial your telephone number from any touch-tone telephone.
2.
When the system plays your announcement, enter the two-digit remote
access code (19 is the preset code; see page 63 to change it).
3.
You can also enter the remote commands (see Remote commands).
Hang up or press *9 to end the call and save all messages that have not
4.
been deleted.
Remote commands
1
Press to listen to all messages.
2
Press to listen to new messages only.
3
Press to delete the current message (during playback).
33
Press twice to delete all old messages.
4
Press to repeat the current message (during playback).
5
Press to stop any operation (including recording).
*5
Press to listen to a list of remote commands.
6
Press to skip to the next message (during playback).
*7
Press to record a new announcement in Annc A.
*8
Press to record a new announcement in Annc B.
*9
Press to end remote access (the call is terminated).
0
Press to turn the answering system on or off.
NOTES:
•
If you do not press any keys after you enter the remote access code, all new messages
play. If there are no new messages, all old messages play.
•
Once the messages have played, the telephone announces the help menu options. If
you do not press any key within 20 seconds, the remote access call
automatically disconnects.
•
When the answering system is turned off, the telephone answers after 10 rings, and
announces, " Please enter your remote access code."
•
When the memory is full, the answering system answers incoming calls after 10 rings and
announces, " Memory is full. Enter the remote access code."
125