Engine Operations; Engine Select - Lowrance EP-60R Fuel Flow Installation/Configuration Instructions

4. Highlight
message will appear: Are you sure you wish to Fill Tank?
NOTE:
You must use the unit's Fill Tank command when filling your fuel
tank to keep the fuel flow updated with correct information on the
amount of fuel in the tank.
5. Select and press
Y
ES
appear: Do you wish to re-calibrate the device?
6. Highlight
N
7. Take your vessel out on the water and burn at least five gallons of
fuel. Be sure you run only ONE engine — the engine connected
to your fuel flow.
8. Fill up your tank again, noting how much fuel you added to the tank.
Compare that number to the Fuel Used figure displayed on your
display unit's screen.
If the amount of fuel you added to the tank and the fuel used figure are
off by more than 3 percent, we recommend the fuel flow be calibrated.
To calibrate a fuel flow:
9. Fill up your tank. Press
and press
ENTER
10. Highlight
and press
ENTER
11 Select the desired tank location and press
.
12. Highlight
appear: Are you sure you wish to Fill Tank? Select
.
ENTER
13. The following message will appear: Do you wish to re-calibrate the
device? Select
14. Repeat these steps for each EP-60R Fuel Flow you want to
calibrate.

Engine Operations

The lower half of the Fuel Management menu covers Engine
Operations, which include: Engine Select, Reset Calibration, Reset Trip
and Reset Seasonal.

Engine Select

Engine Select allows you to choose the desired engine when resetting
calibration, resetting trip fuel and resetting seasonal fuel.
and press
F T
ILL ANK
ENTER
and press
ENTER
O
.
F M
UEL ANAGEMENT
.
and press
F T
ILL ANK
and press
Y
ES
ENTER
. The following confirmation message will
.
twice, select
MENU
and press
ENTER
ENTER
.
ENTER
41
. The following confirmation
NMEA 2000
. Highlight
.
ENTER
. The following message will
or
N
ETWORKING
T L
ANK OCATION
and press
Y
ES