Advertisement
Quick Links
This instruction manual explains how to install your EP-10 fuel flow
sensor and connect it to a NMEA 2000
network components. You must refer to your digital gauge, sonar or
GPS unit's manual for sensor operation instructions.
Caution:
Installing LowranceNET NMEA 2000 devices is significantly
different from installing earlier Lowrance components without
NMEA 2000 features. You should read all of the installation
instructions before proceeding. You should decide where to
install all components before drilling any holes in your vessel.
Some sonar or GPS units may require a software upgrade to display
NMEA 2000 data correctly and a manual addendum describing how to
operate the sensor. You can download these free and get additional
information on the NMEA 2000
our web site, www.lowrance.com.
WARNING:
Do not use this sensor with diesel engine fuel systems.
The EP-10 is designed only for gasoline engines. Please
see fuel filter warning on page 4 for additional
information.
Sensor
module
EP-10 Fuel Flow
Electronic Sensor
Installation Instructions
The EP-10 Fuel Flow sensor.
network using LowranceNET
compatible LowranceNET system at
1
`Pub. 988-0154-431
Blue female NMEA
2000 connector
Advertisement
Related Manuals for Lowrance EP-10
Summary of Contents for Lowrance EP-10
-
Page 1: Installation Instructions
EP-10 Fuel Flow Electronic Sensor Installation Instructions This instruction manual explains how to install your EP-10 fuel flow sensor and connect it to a NMEA 2000 network components. You must refer to your digital gauge, sonar or GPS unit's manual for sensor operation instructions. - Page 2 NMEA 2000 network or it will not function. Tools and Supplies Your EP-10 sensor comes with a T connector. The T connector is needed to attach the sensor to a LowranceNET NMEA 2000 network. If you are connecting to an existing LowranceNET network, those are all the electronic components you need.
- Page 3 After installation remember to clean up any spilled fuel. Cut the fuel hose where you intend to install the EP-10 sensor. Slide a clamp over the hose coming from the tank and push the hose onto the bottom (inlet) hose barb.
- Page 4 As with any fuel system, we recommend you always carry onboard a spare fuel filter and an in-line 3/8" splice barb. This allows you to remove a clogged EP-10 fuel sensor or fuel filter and restore engine operation if the fuel filter fails. It is strongly recommend that you inspect your entire fuel system at regular intervals.
- Page 5 The backbone is like the phone wiring running through a house. Phones in a house must be connected to each other to communicate, and in the same way only sensors and display units plugged into the NMEA network can share information.
- Page 6 T connector. Existing network node Add a new device to a NMEA 2000 bus by attaching a T connector between two T connectors, between a T connector and the end terminator, or between two backbone extension cables.
- Page 7 LOWRANCE ELECTRONICS FULL ONE-YEAR WARRANTY "We," "our," or "us" refers to LOWRANCE ELECTRONICS, INC., the manufacturer of this product. "You" or "your" refers to the first person who purchases this product as a consumer item for personal, family or household use.
-
Page 8: Accessory Ordering Information
For Eagle: 8 a.m. to 5 p.m. Central Standard Time, M-F Lowrance Electronics and Eagle Electronics may find it necessary to change or end their shipping policies, regulations and special offers at any time. They reserve the right to do so without notice.