Lowrance EP-60R Fuel Flow Installation/Configuration Instructions page 23

1. Press
MENU
press .
ENTER
2. Highlight
B
appear.
Bus Devices highlighted in the System Setup menu (left). Searching
Bus Devices window (center) with Bus Devices list (right).
3. Select
U C
N
appear: Press Enter to Configure Fuel Flow Snsr.
4. Press
ENTER
Select Engine menu will appear. (If your unit is set to a single-tank
configuration, the Select Engine menu will not appear. The fuel flow
will automatically be given the configuration name Eng FFlow.)
5. Select the desired engine and press
the Bus Devices list. Press
display.
To unconfigure a fuel flow:
You will use the Unset Engine command to unconfigure a fuel flow.
To unset engine:
1. Press
MENU
press .
ENTER
2. Highlight
B
3. Select the desired fuel flow and press
will appear. Select
message will appear: Press Enter to UnConfig Device Name
4. Press
ENTER
where the fuel flow you unconfigured will be shown as UnCfg F Flow.
To reconfigure a fuel flow:
You will use the Change Engine command to reconfigure a Fuel Flow.
Change Engine, however, will only appear on the LMF-400 menu if a
multiple engine setting was chosen during Boat Setup. If all the fuel
flows on your vessel are configured, you will have to unconfigure a fuel
, use the
UP
and press
D
US EVICES
and press
F F
FG LOW
. If your unit is configured for more than one tank, the
, use the
UP
and press
D
US EVICES
U
NSET
and you will be directed back to the Bus Devices list,
and keys to select
DOWN
ENTER
ENTER
ENTER
repeatedly to return to the main
EXIT
and keys to select
DOWN
to open the Bus Devices list.
ENTER
and press
E
NGINE
23
S
. The Bus Devices list will
. The following message will
. You will be directed to
S
. The Fuel Flow menu
ENTER
. The following
ENTER
and
S
YSTEM ETUP
and
S
YSTEM ETUP
.