Lowrance EP-60R Fuel Flow Installation/Configuration Instructions page 26

2. Press
MENU
press .
ENTER
3. Highlight
F
4. Select
R
EFILL
more than one tank, the Select Tank menu will open.
5. Select the tank you refilled and press
window (ReCalibrate?) will appear with two options: Yes and No. Select
and press
N
O
after refilling the fuel tank. Press
6. Take your boat out, but run only ONE engine — the engine
connected to the fuel flow. Burn at least 5 gallons of fuel, then fill up
the tank again, noting how much fuel was added to the tank. Check the
Fuel Manager page for the fuel used figure calculated by the LMF-400.
7. Compare the amount of fuel added when you filled up the tank with
the LMF-400 Fuel Used figure. If the difference between these two
numbers is greater than 3 percent, you need to calibrate the unit.
To calibrate a fuel flow:
8. Press
MENU
press .
ENTER
9. Highlight
F
10. Select
R
EFILL
more than one tank, the Select Tank menu will open. Select the tank
you refilled and press
11. The Recalibration menu will appear with two options: Yes and No.
Select and press
Y
ES
12. The Filled Fuel Quantity window will appear. Use the
keys to input the amount of fuel you added to the tank and press
DOWN
.
ENTER
13. Repeat these steps for each fuel flow you want to calibrate.
NOTE:
It is a good idea to periodically check the calibration of a fuel flow.
Reset Calibration
The Reset Calibration command allows you to set fuel flow calibration
to factory defaults.
To reset calibration:
1. Press
MENU
press .
ENTER
, use the
UP
and press
S
UEL ETUP
and press
T
ANK
. The following message will appear: Press Enter
ENTER
, use the
UP
and press
S
UEL ETUP
and press
T
ANK
ENTER
.
ENTER
, use the
UP
and keys to select
DOWN
.
ENTER
. If your unit is configured for
ENTER
.
ENTER
and keys to select
DOWN
.
ENTER
. If your unit is configured for
ENTER
.
and keys to select
DOWN
26
S
YSTEM
. A Recalibration
ENTER
S
YSTEM
S
YSTEM
and
S
ETUP
and
S
ETUP
and
UP
and
S
ETUP