JVC RX-D201S Service Manual page 6

3.1.3 Removing the rear panel
(See Fig.5)
• Remove the top cover.
(1) From the back side of the main body, remove the strain re-
lief from the rear panel in the direction of the arrow and re-
move the power cord.
(2) Remove the twenty-four screws E attaching the rear panel.
[For Australia/China]
(3) Remove the twenty-five screws E attaching the rear panel.
[For Europe]
3.1.4 Removing the tuner
(See Fig.6)
• Remove the top cover.
(1) From the top side of the main body, disconnect the card
wire from the connector
(2) From the back side of the main body, remove the two
screws F attaching the tuner to the rear panel and take out
the tuner.
3.1.5 Removing the subwoofer board
(See Fig.6)
• Remove the top cover.
(1) From the top side of the main body, disconnect the wire
from the connector CN524
(2) From the back side of the main body, remove the screw G
attaching the subwoofer board to the rear panel and take
out the subwoofer board.
3.1.6 Removing the compulink board
(See Fig.6) [For Australia/China]
• Remove the top cover.
(1) From the top side of the main body, disconnect the wire
from the connector CN565
(2) From the back side of the main body, remove the screw H
attaching the compulink board to the rear panel and take
out the compulink board.
CN1 on the tuner.
on the subwoofer board.
on the compulink board.
[For Australia/China]
Power cord
Strain relief
E
E
[For Europe]
Power cord
Strain relief
E
Fig.5
Compulink board
Tuner
CN565
H
Rear panel
Fig.6
E
Rear panel
E
Rear panel
E
Subwoofer board
CN524
CN1
F G
Rear panel
(No.MB418)1-9