JVC RX-D201S Service Manual page 11

3.1.18 Removing the DSP connect board
(See Fig.15)
• Remove the top cover, rear panel, tuner and volume board.
Disconnect the connector CN602
from the input board in an upward direction.
Note:
When removing the DSP connect board, take care not to break
the claw of the connector on the input board.
3.1.19 Removing the input board
(See Fig. 15)
• Remove the top cover, rear panel, tuner, volume board, scart
board and DSP connect board.
Reference:
Remove the tie bands bundling the wires.
(1) Disconnect the wire from the connector
speaker terminal 2 board.
(2) Disconnect the wire from the connector
connect 1 board.
(3) Disconnect the wires from the connectors (CN530, CN531,
CN552) on the input board.
(4) Disconnect the parallel wire from the connector
the input board.
(5) Remove the three screws T and take out the input board
from the main body.
1-14 (No.MB418)
on the DSP connect board
CN209 on the
CN513 on the OSD
CN540 on
[For Australia/China]
OSD connect 1 board
CN530
CN540
CN531
CN552
T
T
Input board
CN602
DSP connect board
Speaker terminal 2 board
[For Europe]
CN530
CN552
CN540
T
T
Input board
CN602
DSP connect board
Speaker terminal 2 board
Fig.15
CN513
T
CN209
OSD connect 1 board
CN531
CN513
T
CN209