JVC RX-D201S Service Manual page 5

3.1.2 Removing the front panel assembly
(See Figs.3 and 4)
• Remove the top cover.
Reference:
Remove the tie bands and wire holder bundling the wires.
(1) Disconnect the card wire from the connector
main amplifier board. (See Fig.3)
(2) Disconnect the wire from the connector
amplifier board. (See Fig.3)
(3) Disconnect the wire from the connector
board. (See Fig.3)
(4) Disconnect the wire from the connector
ume board. (See Fig.3)
(5) Remove the three screws C attaching the front panel as-
sembly. (See Fig.3)
(6) Remove the screw C attaching the OSD connect 2 board.
(See Fig.3)
(7) From the bottom side of the main body, remove the four
screws D attaching the front panel assembly. (See Fig.4)
(8) Release the joints a and remove the front panel assembly
in the direction of the arrow. (See Fig.4)
1-8 (No.MB418)
[For Australia/China]
CN102 on the
CN351 on the main
CN552 on the input
CN661 on the vol-
[For Europe]
Front panel assembly OSD connect 2 board
C
CN102
C
CN552
CN661
Input board
Volume board
Front panel assembly
C
CN102
C
CN661
CN552
Volume board
Input board
Fig.3
D Front panel assembly
a
Fig.4
C
CN351
Main amplifier board
OSD connect 2 board
C
CN351
Main amplifier board
D
a