Configure Nmea; Coordinate System Selection - Lowrance LMS-332C Installation And Operation Instructions Manual

Configure NMEA

You can configure the unit to use specific NMEA sentences.
1. Press
MENU
2. Press ↓ to
C
3. A menu appears showing the prefixes of the available NMEA sen-
tences. A check mark next to a prefix means the prefix is in use. Use ↑
↓ → ← to select a prefix, then press
again to check the box and turn a prefix on.)
ENT
4. When the desired prefixes are checked or unchecked, press
| |
EXIT EXIT EXIT

Coordinate System Selection

The Coordinate System Menu lets you select the coordinate system to
use when displaying and entering position coordinates.
Menus for changing coordinate system used to display positions.
To get to Coordinate System Selection:
1. Press
MENU
2. Press ↓ to
C
This unit can show a position in degrees (36.14952°); degrees, minutes
and thousandths of a minute (36° 28.700'); or degrees, minutes, seconds
and tenths of a second (36° 28' 40.9"). It can also show position in: UTM
(Universal Transverse Mercator) projection; MGRS (Standard); MGRS
(Standard + 10); Map Fix; Loran TD; British, Irish, Finnish, German,
New Zealand, Swedish, Swiss, Taiwan and Greek.
UTM's are marked on USGS topographic charts. This system divides
the Earth into 60 zones, each 6 degrees wide in longitude.
| |↓ to
MENU S
P
OMMUNICATIONS
| to return to the previous page.
EXIT
| |↓ to
MENU GPS S
S
OORDINATE YSTEM
|
S ENT
YSTEM ETUP
| |↓ to
ENT
ORT
ENT
| .
ENT
ETUP
| .
ENT
152
.
C NMEA
ONFIGURE
to turn off the prefix. (Press
| .
ENT