Table 9: Advanced Settings - Grandstream Networks HT502 User Manual

Admin Password
Layer 3 QoS
Layer 2 QoS
STUN Server
Keep-alive interval
Use STUN to detect
network connectivity
Firmware Upgrade
and Provisioning
Via TFTP Server
Via HTTP / HTTPS
Server
FIRMWARE VERSION 1.0.8.4

TABLE 9: ADVANCED SETTINGS

This contains the password to access the Advanced Web Configuration page. This field is
case sensitive. Only the administrator can configure the "Advanced Settings" page.
Password field is purposely left blank for security reasons after clicking update and saved.
The maximum password length is 25 characters.
This field defines the layer 3 QoS parameter which can be the value used for IP
Precedence or Diff-Serv or MPLS. Default value is 12.
Value used for layer 2 VLAN tag. Default setting is blank.
IP address or Domain name of the STUN server.
This parameter specifies how often the HT502 sends a blank UDP packet to the SIP
server in order to keep the "hole" on the NAT open. Default is 20 seconds. Minimum
value is 20 seconds.
Use STUN keep-alive to detect WAN side network problems. If keep-alive request does
not yield any response for configured number of times, the device will restart the TCP/IP
stack. If the STUN server does not respond when the device boots up, the feature is
disabled.
Enables HT502 to download firmware or configuration file through either the TFTP, HTTP
or HTTPS server.
This is the IP address of the configured TFTP server. If selected and it is non-zero or not
blank, the HT502 retrieves the new configuration file or new code image from the
specified TFTP server at boot time. After 5 attempts, the system will timeout and will start
the boot process using the existing code image in the Flash memory. If a TFTP server is
configured and a new code image is retrieved, the new downloaded image is saved into
the Flash memory.
Note: Please do NOT interrupt the TFTP upgrade process (especially the power supply)
as this will damage the device. Depending on the local network, this process can take up
to 15 or 20 minutes.
The URL for the HTTP/HTTPS server used for firmware upgrade and configuration via
HTTP.
For example, http://provisioning.mycompany.com:6688/Grandstream/1.0.0.67":6688" is
the specific TCP port where the HTTP or HTTPS server is listening; it can be omitted if
using default port 80.
Note: If Auto Upgrade is set to No, HT502 will only do HTTP/HTTPS download once at
boot up.
HT502 USER MANUAL Page 31 of 49