Belt Pulley Removal; Damper Capstan Removal; Motor Capstan Ass'y Removal - Sony SLV-D990P R Service Manual

QQ
3 7 63 1515 0

2-4-25 Belt Pulley Removal

1) Remove the Belt Pulley 1.
Note: Take extreme care not to get grease on Belt Pulley 1 at
assembling or reassembling.
1 BELT PULLEY
TE
Fig. 2-38 Belt Pulley Removal
L 13942296513

2-4-26 Damper capstan Removal

1) Lift the Hook in the direction of arrow use the Flat Tip. (Refer
to Fig. 2-39)
2) Rotate the Damper Capstan in the direction of allow.
Note: Damper Capstan use the Sankyo Capstan Motor (FQVB65)
Only.
www
.
Fig. 2-39 Damper Capstan Removal
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8

2-4-27 Motor Capstan Ass'y Removal

1) Remove the 3 Screws 1.
2) Remove the Motor Capstan Ass'y 2.
Assembly:
1) Match the 3 holes of Motor Capstan Ass'y 2 to the 3 holes of
Main Base. Be careful not to drop or knock the Motor Capstan
Ass'y 2.
2) Tighten the 3 Screws 1 in the direction of arrow as shown detail
drawing.
Note: After tightening screws, check if there is gap between the
head of screws and the top side of Main Base. There should have no
gap between the head of screws and the top side of Main Base.
After reinstalling, adjusting the tape transport
system again.
1 3 SCREWS
Q Q
3 6 7 1 3 1 5
Fig. 2-40 Motor Capstan Ass'y Removal
co
.
2-19
9 4 2 8
C
A
B
0 5 8 2 9 9 4 2 8
2 MOTOR CAPSTAN ASS'Y
m
9 9
9 9