Cautions, And Do's And Don'ts - Oki C810 Maintenance Manual

Oki Data CONFIDENTIAL

3.1 Cautions, and do's and don'ts

• Do not install the printer in any high-temperature location or a near heat source.
• Do not install the printer in a location where chemical reaction may occur (laboratory and
the like).
• Do not install the printer in the proximity of inflammable solvents, such as alcohol and
paint thinner.
• Do not install the printer within reach of children.
• Do not install the printer on an unstable surface (e.g., on a rickety bench or on a slanting
place).
• Do not install the printer in a location with moisture or heavy dust, or in direct sun.
• Do not install the printer in an environment with sea wind or corrosive gas.
• Do not install the printer in a location with heavy vibration.
• In the event that the printer is inadvertently dropped or its cover is damaged, remove the
power plug from the power outlet and contact the customer information center.
Such mishap could lead to an electric shock, fire or injury.
• Do not connect any power cord, printer cable or grounding wire in any other manner than
the way specified in the manual. Failure to observe the above could result in fire.
• Do not stick in an object into the vent hole.
Such action could lead to an electric shock, fire or injury.
• Do not place a glass filled with water or the like on the printer.
Such action could lead to an electric shock or fire.
• When the printer cover is opened, be careful not to touch the fuser unit.
It may cause burns.
• Do not throw the toner cartridges or the image drum cartridges into fire.
Dust explosion could cause burns.
• Do not use a highly combustible spray near the printer.
It may case a fire because the printer contains parts that get extremely hot.
• In the event that the cover becomes unusually hot, emits smoke, bad smell, or
abnormal noise, remove the power plug from the power outlet and contact the customer
information center.
It may lead a fire.
44015503TH Rev. 1
• If water or any other liquid enters the inside of the printer, remove the power plug from
the power outlet and contact Customer Center.
Fire could break out.
• If someone drops foreign objects such as a clip in the printer, remove the power plug
from the outlet and take out the foreign objects.
It may cause an electric shock, fire, or injury.
• Do not operate or disassemble the printer in any other manner than the way specified in
the manual.
Failure to observe this warning could result in an electric shock, fire or injury.
• Do not install the printer in a location where its vent hole is blocked.
• Do not install the printer directly on a shag carpet or rug.
• Do not install the printer in a sealed room or other location with poor ventilation or
permeability.
• Make sure to ventilate sufficiently when continuously using the printer in a small room for
a long time.
• Install the printer away from a strong magnetic field or noise source.
• Install the printer away from a monitor or Tv.
• To move the printer, hold both sides of the printer.
• This printer, which weighs approximately 40 kg, should be lifted by two or more people.
• While the printer power is on or the printer is printing, do not come close to the paper
exit. Such action could lead to injury.
When the precautionary notes concerning the installation and operation are explained, the
user should be referred to the precautionary notes given in the user's manual. Especially, give
thorough explanation on the power cord and the grounding wire.
3. INSTALLATION
32 /