Manual Density Adjustment Setting - Oki C810 Maintenance Manual

Oki Data CONFIDENTIAL

5.5 Manual density adjustment setting

C830 is shipped with the auto density adjustment mode enabled. When the mode is disabled
by a user, the printer may print density out of adjustment while being used. Manually perform
density adjustment setting when the printer prints an improper density.
Note! The setting must be performed with the printer in a static state. Do not
perform it while the printer warms up.
(1) Press the MENU up-arrow ( ) or MENU down-arrow ( ) button more than one
time. Press the ENTER button when Calibration appears.
(2) Press the MENU up-arrow ( ) or MENU down-arrow ( ) button to select Adjust
Density Execute. Press the ENTER button.
(3) Press the ENTER button.
Auto density adjustment starts, the operator panel display providing a message stating
that density is being adjusted.
44015503TH Rev. 1
5. MAINTENANCE MENUS
148 /