Boot Menu List - Oki C810 Maintenance Manual

Oki Data CONFIDENTIAL

5.6 Boot Menu List

To display Boot Menu, turn on the printer while holding down the Set (
Memo Displaying Boot Menu requires entry of a password. The password defaults to
six as (aaaaaa).
Category Option Settings
Enter ************
Password
Parallel Parallel Enable
Setup Disable
Bi-Direction Enable
Disable
ECP Enable
Disable
Ack Width Narrow
Medium
Wide
Ack/Busy Ack in Busy
Timing Ack while Busy
I-Prime 3 microseconds
50 microseconds
Disable
Offline Enable
Receive Disable
44015503TH Rev. 1
) button.
Function
Enters a password to display Boot Menu. The
password is six to twelve digits or lower-case
alphanumeric characters and defaults to six as
(aaaaaa).
Sets whether to enable or disable the parallel
interface.
Sets whether to make the parallel interface bi-
directional or not.
Sets whether to enable or disable the ECP mode.
Sets the compatible-reception ACK width.
NARROW: 0.5 µs
MEDIUM: 1.0 µs
WIDE: 3.0 µs
Sets the order of outputting compatible-reception
BUSy and ACK signals.
Sets an I-PRIME signal valid time period or
disable I-Prime signals.
Sets whether to enable or disable the functionality
that maintain a state ready for reception without
changing interface signals even when an alarm is
issued.
Category Option Settings
USB USB Enable
Setup Disable
Speed 480Mbps
12Mbps
Soft Reset Enable
Disable
Offline Enable
Receive Disable
Serial Enable
Number Disable
Security Job Off
Setup Limitation Encrypted Job
Reset Cipher Execute
Key
Storage Check File Execute
Setup System
Check All Execute
Sectors
Enable HDD No
yes
Erase HDD Execute
Enable No
Initialization yes
5. MAINTENANCE MENUS
Function
Sets whether to enable or disable the USB
interface.
Sets the maximum USB interface transmission
speed.
Sets whether to enable the Soft Reset command.
Sets whether to enable or disable the functionality
that maintain a state ready for reception without
changing interface signals even when an alarm is
issued.
Sets whether to enable or disable the USB serial
number.
Restricts jobs to accept, i.e. sets whether to
accept only encrypted authentication jobs. This
option is displayed when an optional internal hard
disk is installed.
Reproduces an encrypted key used for a security
hard disk. When an optional internal hard disk is
installed and the security hard disk functionality is
enabled, this option is displayed.
Resolves a mismatch between the actual
(available) and displayed available space of the
file system and restores management data (FAT
information).
Restores improper HDD sector information and
corrects a mismatch between the actual and
displayed available space of the file system.
When set to NO, deeming the printer with no
HDDs irrespective of whether an HDD is installed
on it, starts the printer when the printer cannot be
started due to HDD damage.
Erases all data stored on an HDD so as that it
cannot be restored. This option is displayed when
an optional internal hard disk is installed.
Disables changes made about the internal hard
disk and flash memory, involving initialization.
149 /