Setting Temperatures; Specifying The Set Dhw Temperature - Buderus Logano plus GB402 Operating Instructions Manual

3.2

Setting temperatures

3.2.1

Specifying the set DHW temperature

B With the set DHW temperature rotary selector [1]
select the required DHW cylinder temperature.
The LED [2] below the rotary selector
illuminates if DHW is being reheated or the
DHW temperature is still below the required
temperature (heat demand).
Status
0 Off
Eco Economy mode
DHW temperature 60 °C
30 – 60 Direct setting at the BC10
in °C
Aut Specified via the programming unit
(preset)
Tab. 2 Setting options on the rotary selector for set DHW temperature
1) The heating program (time switch) on the room controller remains active so that DHW is not heated during night mode.
2) The LED below the rotary selector illuminates if DHW is being reheated or the DHW temperature is below the required temperature
(heat demand).
Logano plus GB402 - Subject to technical modifications.
Explanation
No DHW provision (only central heating).
1)
, DHW is only heated to 60 °C again if the temperature
has dropped significantly. This reduces the number of
burner starts and saves energy. However, the water may
be somewhat cooler in the first few moments.
1)
The temperature is set at the BC10 and can then no
longer be adjusted with the programming unit.
1)
The temperature is set at the programming unit (RCxx).
If no programming unit is connected, 60 °C is the
maximum DHW temperature.
1
2
Fig. 3 Set DHW temperature rotary selector
3
Operation
6 720 617 694-04.1RS
LED
Off
2)
ON
2)
ON
2)
ON
9