Electrolux EDW 1506 Service Manual page 26

6.7.1. Input philosophy: alter program
l
Alter program during the prestart mode
The door is still open at that moment!
Display blinkt
LD3
1.
105
Display blinkt
2.
93
Display blinkt
LD2
3.
165
S2
1. Program has been selected but did not yet start
Ä Corresponding program LED is lit.
Ä Presumable run time is flashing in the display.
2. By pressing the new desired program key shortly it is possible to alter directly.
LD5
Options already selected before are cleared and have to be selected anew.
Ä New selected program LED is lit.
S5
Ä Presumable new run time is flashing in the display.
3. Before the door has been closed it can be altered as many times as one wants.
Only when the door has been closed, the program will start automatically.
Special feature when a start time was selected before!
1. Program and start time have been selected but did not yet start.
Ä LEDs of program and "SZV" are lit.
Ä Programmed start time is flashing in the display.
2. By pressing the new desired program key shortly it is possible to alter directly.
The start-time preselection already selected is preserved after the alteration! Program
options already selected before, however, are deleted and must be selected anew.
Ä New program LED and "SZV" LED are lit.
Ä Run time to be expected is flashing in the display for 2 sec., afterwards the
If the selected start time is already running down (the time is permanently lit in the
display) you have to press the new desired program key a longer time (about 6 seconds)
for alteration.
start time is flashing again.
26
EDW 1503 / VGA
LD1 LD2 LD3 LD4 LD5 LD6
LD10
1 99
LD11
LD12
S1 S2 S3 S4 S5 S6 S0