Table of Contents
Advertisement
16"
Fig. 4A Minimum clearance to wall and ceiling.
Heat Resistant
Material
Universal
Canopy
Fireplace Opening
Fig. 4C Mantel clearance with Optional Universal Canopy,
UC-2 (black) or UC-2PB (polished brass).
Installation of WRST or WRD Wireless Remote
T107
To begin installation of your wireless remote (WRD or WRST),
Mantel clearance
you must first remove the two screws retaining the cover for the
with canopy
10/27/03 djt
ignitor/receiver delete plate as shown on the log set in Figure 5,
letter "E". This allows the removal of the delete plate blocking
the holes for the receiver. Your receiver will be similar to that
shown in Figure 6, letter "G".
There will be a battery terminal and two wire leads. Install the
receiver as shown in Figure 6 by attaching the two silver push-
on clips over the mounting ears as shown in Figure 6, letter "D".
Line up the receiver as shown in the same diagram and push
the receiver up flush to the plate. The switch and pickup will
protrude from the front of the mounting plate.
Using the screws removed from the delete plate removal,
tighten the receiver to the plate. Now turn the whole log set
upside down and refer to Figure 7.
Run the red and white wires, letter "C", from the receiver to the
valve as shown in Figure 7. The wires should now be in front of
the valve's terminal shown in Figure 8. The two wires, letter "A",
Figure 8, should not be removed or changed. Remove switch
wires, letter "B". The two wires from the receiver can now be
connected to the two outer terminals on the valve, making sure
it is the two outer terminals and not the center one (see Figure
9). With these two connections made, return the log set right
side up. You may now refer to the lighting instructions for use.
The log set should not be modified to accept any other type
of remote control and no guarantee may be made regarding
proper function.
20008055
42"
10"
8"
T105
20"
Minimum
Min.
6"
clearance to
16"
walls & ceiling
1¹⁄₈"
Min.
10/27/03 djt
12"
Min.
8"
Min.
No Canopy Used
Heat Resistant
Material
Fireplace Opening
Fig. 4B Mantel clearances for existing fireplaces.
Combustible Mantel
T106
Mantel clearance
Noncombustible
no canopy
10/27/03 djt
2" Minimum
Clearance
Fig. 4D Side clearances and projection.
T107
side clearance
and projection
D
10/27/03 djt
C
E
F
A Manual OFF/ON
Switch
B Piezo Ignitor
C Receiver
Fig. 5 Wireless remote installation.
10"
8"
27"
6"
Min.
23"
1¹⁄₈"
Min.
19"
Min.
15"
Min.
10"
Min.
Facing
Fireplace
Opening
Maximum Projection:
7"
A
B
D Log
E Receiver and battery
installation and removal screws
T109
F Switch (OFF/ON)
wireless remote
10/27/03 djt
T109
9
Advertisement
Table of Contents
