Sony NSR-1100 User Manual page 100

[I/O Device Action] Tab
Number of Settings
This displays the number of IO devices target for the
action.
[Add Device] Button
This displays a dialog box for adding an IO device as
a target for the action.
IO Device Drop-down Menu
Select the I/O device.
Pin List
Select the check boxes of the pins for which to change
the state.
[System Action] Tab
100
Configuring Action Settings
Send e-mail
Select the check box to send a notification by mail to a
specified mail address.
E-mail Address
Enter an e-mail address.
For details on mail notification settings, refer to
"Configuring Mail Notification Settings"
(page 101).
Attach Camera Image
Select the check box to send a still image as a mail
attachment.
If you select this, specify the camera for recording the
still image.
Note
If the codec of the camera is MPEG4/H.264 or
masking is set for the camera, the image is not
attached.
Each camera
Attach the still images recorded with the camera for
which the event occurred.
For example, when motion detection of camera A
and sensor input of camera B are configured as the
triggers and motion detection occurs for camera A,
the still images recorded with camera A are
attached. When the sensor input of camera B turns
on, the still images recorded with camera B are
attached.
Specified Camera
Attach still images recorded with a specified
camera.
Message
Enter the message of the mail. It can be up to 32
characters long.
Change Layout
Select the check box to change the monitor layout of
monitor 1.
If you select this, select the monitor layout to display
on monitor 1.
Beep
Select the check box to play a beep tone.
If you select this, select a beep tone.
I OK
This creates an event/alarm action in accordance with the
set values, and closes the dialog box.
J Cancel
This cancels your settings, and closes the dialog box.