Initial Assembly - Pride Jazzy Select series Owner's Manual

INITIAL ASSEMBLY

Your power chair may require some assembly either before initial use or after transportation.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be reused as it may cause damage
to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local
hardware stores or through your authorised Pride Dealer.
Seat Installation (Select and Select 6)
It may be necessary to install the seat either prior to
initial operation or after transporting your power
chair.
WARNING! Do not pick up the seat
frame by the armrests. They are free
to pivot, and you may lose control of
the seat if they do so.
To install the seat:
1. Slide the seat down onto the power base. See fig-
ure 13.
NOTE: The bottom hole on the seat post is equipped
with an internal welded pin, which sets the seat
height in the lowest position. If a seat height other
than the lowest position is desired, you must install
the supplied clevis pin into either the middle hole or
top hole on the seat post before installing the seat.
2. Tighten and clamp the quick-release fastener.
See figure 14.
3. Install the controller into one of the armrests.
Tighten the setscrew with the supplied hex key.
See figure 13.
4. Lift the armrest straight up, then route the con-
troller harness and secure with wire ties as shown
in figure 13.
NOTE: It is important that the armrest be lifted
straight up prior to securing the controller harness
with wire ties.
MANDATORY!
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the
inside of the armrest pad. Use
correct tie-down points for controller
harness to prevent the harness from
getting caught in the drive tires,
pinched in
damaged
doorways.
5. Plug the controller harness into the connector on
the power base. See figure 6, 7 or 8.
Jazzy Select Series
I V . A S S E M B L Y
Prevent controller
the seat frame,
when passing through
WIRE
TIES
SETSCREW
QUICK RELEASE
FASTENER
POWER BASE
Figure 13. Seat and Controller Assembly
or
www.pridemobility.com
SEAT
CONTROLLER
CLEVIS PIN
23