Initial Assembly; Seat Installation; Seat And Controller Assembly - Pride Jazzy Select 6 Owner's Manual

INITIAL ASSEMBLY

Your power chair may require some assembly either before initial use or after transportation.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be reused as it may cause damage
to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local
hardware stores or through your authorized Pride Provider.
Seat Installation (Select and Select 6 only)
It may be necessary to install the seat either prior to initial
operation or after transporting your power chair.
WARNING! Do not pick up the seat
frame by the armrests. They are free
to pivot, and you may lose control of
the seat if they do so.
To install the seat:
1. Slide the seat down onto the power base. See figure 13.
NOTE: The bottom hole on the seat post is
equipped with an internal welded pin, which sets
the seat height in the lowest position. If a seat
height other than the lowest position is desired,
you must install the supplied clevis pin into either
the middle hole or top hole on the seat post before
installing the seat.
2. Tighten and clamp the quick-release fastener. See
figure 14.
3. Install the controller into one of the armrests. Tighten
the setscrew with the supplied hex key. See figure 13.
4. Lift the armrest straight up, then route the controller
cable and secure with wire-ties as shown in figure 13.
NOTE: It is important that the armrest be lifted
straight up prior to securing the controller cable
with wire-ties.
MANDATORY! Prevent controller
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for the controller harness
to prevent the harness from getting
caught in the drive tires, pinched in
the seat frame, or damaged when
passing through doorways.
5. Plug the controller cable into the connector on the
power base. See figure 6, 7, or 8.
Jazzy Select Series
I V . A S S E M B L Y
Figure 13. Seat and Controller Assembly
www.pridemobility.com
WIRE TIES
SETSCREW
QUICK RELEASE
FASTENER
POWER BASE
SEAT
CONTROLLER
CLEVIS PIN
23