Initial Assembly - Pride Jazzy Elite 6 Owner's Manual

INITIAL ASSEMBLY

Your power chair may require some assembly either before initial use or after transportation.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be reused as it may cause damage
to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local
hardware stores or by contacting your authorized Pride Provider.
Seat Installation
It may be necessary to install the seat either prior
to initial operation or after transporting your
power chair.
WARNING! Do not pick up the seat
frame by the armrests. They are
free to pivot, and you may lose
control of the seat if they do so.
To install the seat:
1. Adjust the upper seat post to the desired
position and insert the bolt through the seat
post and secure with the nut. See figure 10.
2. Slide the seat down onto the upper seat post.
See figure 10.
3. Install the controller into one of the armrests.
Tighten the setscrew with the supplied hex
key. See figure 10.
4. Lift the armrest straight up, then route the
controller harness and secure with wire ties as
shown in figures 10 and 11.
NOTE: It is important that the armrest be lifted
straight up prior to securing the controller
harness with wire ties.
MANDATORY! Prevent controller
harness damage! Avoid routing
the controller harness on the
outside of the armrest pad. Route
the harness under the armrest or
toward the inside of the armrest
pad. Use correct tie-down points
for the controller
prevent the harness from getting
caught in the drive tires, pinched
in the seat frame, or damaged
when passing through doorways.
5. Plug the controller harness into the connector
on the power base. See figure 6.
Jazzy Elite 6
I V . A S S E M B L Y
Figure 10. Seat and Controller Assembly
harness to
Figure 11. Controller Harness Routing
www.pridemobility.com
SETSCREW
POWER BASE
WIRE TIES
SETSCREW
SEAT
CONTROLLER
UPPER SEAT POST
LOWER SEAT POST
WIRE TIES
21