The Wireless Connection To A Network Does Not Work; The Battery Discharges Too Quickly; Acoustic Warning; Error Messages On The Screen - Fujitsu STYLISTIC Q335 Operating Manual

Troubleshooting and tips

The wireless connection to a network does not work

Thewireless connectiontoanetwork does notwork
Cause
The wireless component is switched off.
The wireless component is switched on. Despite
this, the wireless connection to a network does
not work.

The battery discharges too quickly

Battery
Cause
The battery is either too hot or too cold. In this
case the battery indicator flashes.
You may have an application running that
consumes a great deal of power due to frequent
accessing of the hard disk or optical drive.
The maximum brightness may have been set
for the screen.

Acoustic warning

Errors Acoustic warnings
Cause
A beep sounds every few seconds.
The battery is almost dead.

Error messages on the screen

Error messages onthescreen Errors
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programs are described in the documentation for these programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our customer service center.
52
Troubleshooting
► Switch the wireless component on (see
"Switching the wireless components on and
off", Page 36).
► Check whether the wireless connection is
enabled by the software.
► Further information on using the wireless
component can be found in the help files.
Troubleshooting
► Bring the Tablet PC up/down to a normal
operating temperature again.
► If the operating time of the battery life is
extremely short, the battery is probably too
old. Replace the battery if necessary.
► Use the AC adapter whenever possible.
► Reduce the brightness of the screen to
lower energy consumption: You will find the
setting under Control Panel – Hardware and
Sounds – Windows Mobility Center.
Troubleshooting
► Charge the battery.
Fujitsu